为什么Motor Profiler实用程序无法使用上述BLDC电机完成Profiler序列？

我们正在尝试使用Motor Profiler实用程序设置一个小型BLDC电机。
-X-细胞核 - IHM07M1
-FOC SDK 4.3
- 自定义电机：2极对BLDC 18VDC，2W @空载，4000 rpm
通过此设置，Motor Profiler无法成功完成分析序列。
在仿形循环期间，在确定电气模型期间，电动机每次仿形尝试都变慢。序列因消息而停止：分析序列需要很长时间。
为什么Motor Profiler实用程序无法使用上述BLDC电机完成Profiler序列？运行“低功率”BLDC电机是否需要进行特殊修改？



以下为原文





We are trying to setup a small BLDC motor with the Motor Profiler utility.

-X-NUCLEO-IHM07M1

-FOC SDK 4.3

-Custom motor: 2 pole pair BLDC 18VDC, 2W @ no load, 4000 rpm

With this setup the Motor Profiler is not able to successfully finish the profiling sequence.

During the profiling cycle the motor is turning slower each profiling attempt during the determination of the electrical model. The sequence stops with the message: profiling sequence takes to long.

Why is the Motor Profiler utility not able to finish the profiler sequence using the BLDC motor mentioned above? Are there special modifications necessary running ‘low’ power BLDC motors?